Textron Jacobsen Ransomes Parkway 3 Meteor LGNN344, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 70 / 236

en-70
8 MAINTENANCE & LUBRICATION
8.1 MAINTENANCE & LUBRICATION CHARTS________________________________
METEOR MAINTENANCE CHART
Interval Item Section
First 50 hours

Change Hydraulic Charge Filter Element
8.5
Daily
10 hours

Check Safety Interlock System.

Check Hydraulic Fluid Level.

Check Tyre Pressure.

Check Engine Bay For Debris.

Check Flails For Free Movement And Damage.

Check Flail Rotor Shaft For Wear And Remove Debris.

Check The Meteor Unit Rear Brace Bar Mounting Screws.
7.2
8.5
4.2
8.10
8.14
8.16
8.16
Weekly
Every 50 hours

Check For Loose Components.

Check For Hydraulic Leaks.
8.10
8.10
End of season
Every 1000 hours

Check Battery Condition.

Change Hydraulic Oil & Filter.

Check And Lubricate Flail Shaft Bearings.

Lubricate the Hydraulic Motor Splined Shaft
8.9
8.5
8.16
8.17
Lubricate Grease fittings
A = Lift Arm Pivot, B =Cutting Unit Pivot, C = Cutting Unit Roll, D = Steering Ram Ball Joint weekly
Lubricate Flail Unit Spherical Roller Bearing, E twice weekly
(see diagram and lubricants chart)
MAGNA 250 & SPORT 200 MAINTENANCE CHART
Interval Item Section
First 50 hours

Change Hydraulic Charge Filter Element
8.5
Daily
10 hours

Check Safety Interlock System.

Check Hydraulic Fluid Level.

Check Tyre Pressure.

Check Engine Bay For Debris.
7.2
8.5
4.2
8.10
Weekly
Every 50 hours

Check For Loose Components.

Check For Hydraulic Leaks.
8.10
8.10
End of season
Every 1000 hours

Check Battery Condition.

Change Hydraulic Oil & Filter.

Lubricate the Hydraulic Motor Splined Shaft
8.9
8.5
8.17
Lubricate all Grease fittings weekly
A = Lift Arm Pivot, B =Cutting Unit Pivot, C = Cutting Unit Bearing Housing, D = Cutting Unit Roll,
D = Steering Ram Ball Joint (see diagram)