Teufel KA.L30, Руководство пользователя

Страница: 108 / 136

108
Adjusting the Brake Unit Friction
Please Note:
Make sure your patient
understands that the brake unit, which
increases the safety during stance phase,
gets activated when weight is put on the
joint. The brake will not be activated if no
weight is put on the joint.
The special combination of brake unit and
stance flexion unit comes in especially
useful when the user is walking downhill,
since the stance flexion remains active
when the brake gets activated. This
means that, thanks to the stance flexion
unit, the joint can be flexed by up to 12°.
#55 #44
#53
#30
#29
The friction of the brake unit can be
adjusted with the setting screws #44 and
#55. To make any adjustments, loosen
locking screw #53. Start the adjustment
with screw # 44, and use screw #55 for
fine adjustment.
EN
FR
ES
IT
DD
DE
KnieAgil® Joints User Manual PSB60
Dynamic Fitting
The following joint settings can be adjusted
if desired. We recommend following the
suggested order of adjustments.
Adjusting the Stance Flexion Unit
The stance flexion unit can be adjusted
with setting screw #29. Take care to always
loosen and later tighten (1Nm) locking
screws #30 when adjusting the stance
flexion unit.
Tighten the screw ­ higher resistance
Loosen the screw ­ lower restistance
Please Note!
Never loosen the setting
screws #29 so much that they protru­
de from the housing of the joint. The
damping bumpers are available in three
different hardnesses. The standard, pre­
installed bumpers are of medium hardness
(bumper color: green). Harder bumpers
(color: brown) and softer bumpers (color:
red) are included with the joint. Always
replace spring guide, spring and spring
insert when replacing the bumpers.
#30
#29