TESTO 0572 0158, Инструкция по эксплуатации

Страница: 58 / 178

5 First steps
58
3. Connect the USB cable to the computer.
4. Via
Start | All Programs | Testo | Testo Saveris Ethernet
Wizard , open the wizard for entering the connection settings.
5. Follow the wizard's instructions and assign the IP address for
the Saveris base.
see Installing Saveris software, page 39
Pos: 70 /TD/Erste Schritte/testo Saveris/Hardware erweitern/03 Ethernet-Fühler einbinden/00 Ethernet-Fühler einsetzen @ 1\mod_1197552336953_79.docx @ 6336 @ 4 @ 1
5.11.3. Integrating Saveris Ethernet probe (optional)
In addition to the Saveris radio probes, you can use probes that are
connected to the Ethernet interface of the Saveris base. This also
enables the data transfer from the probe to the base over long
stretches if you do not wish to use a router or converter.
All Ethernet components (Ethernet probe, converter, extender,
base where applicable) must be assigned IP addresses through the
programming adapter (0440 6723) via the Ethernet wizard.
If your computer has the Dynamic Host Configuration
Protocol (DHCP), the Ethernet components
automatically retrieve the IP address. Because the
DHCP address changes as standard following a certain
period of time, the base should be assigned a fixed IP
address. The IP address of the base must be manually
assigned to the probes, extenders and converters
through the adapter.
This chapter contains all required information for this.