Terumo BCT Quantum Cell Expansion System, Руководство оператора

Страница: 115 / 204

Condition Media
Note: Use the information in “Performing Tasks” to complete this task.
The purpose of this task is to allow the media to reach equilibrium with the provided gas supply before
loading the cells. This task includes two separate steps:
•
Step 1: provides rapid contact between the media and the gas supply by using a high EC circulation
rate.
• Step 2: maintains the system in a proper state until the operator is ready to load the cells.
Table 8-1 describes the types of solution that are needed to attach to each line when performing
Condition Media. These solutions and corresponding volumes are based on the factory default settings
for this task.
Table 8-1: Solutions for Condition Media
Line
Solution
Attached to the
Line
Required Volume (estimate based on factory default settings)
Cell None N/A
Reagent None N/A
IC Media None N/A
Wash None N/A
EC Media Media without
protein 0.1 L plus 6 mL/hour
Condition Media pathway:
Task
>
System Management
>
Condition Media
1.
Confirm the settings for step 1 shown in Table 8-2.
Table 8-2: Step 1 Settings for Condition Media
Setting Factory Default Setting Options
IC Inlet None N/A
IC Inlet Rate 0 mL/min N/A
IC Circulation Rate 100 mL/min N/A
EC Inlet EC Media Reagent, IC Media, EC Media, Wash
EC Inlet Rate 0.1 mL/min N/A
EC Circulation Rate 250 mL/min N/A
System Management Tasks
8-6 Quantum
®
Cell Expansion System • Operator's Manual for Software Version 2.1