Terex Genie Z-45/25 Bi-Energy, Руководство по обслуживанию

Страница: 65 / 213

Part No. 237062 Z-45/25 Bi-Energy • Z-45/25J Bi-Energy 3 - 39
September 2015 Section 3 • Scheduled Maintenance Procedures
3 Lower the boom to the stowed position.
4 Remove drive chassis covers from both the
steer end and the non-steer end of the machine.
5 Check to be sure that each bearing mounting
bolt under the drive chassis is torqued in
sequence to specification. Refer to Section 2,
Specifications .
Counterweight
Bolt torque sequence
(from serial number 23236)
D-7
Inspect for Turntable Bearing
Wear
Periodic inspection of turntable bearing wear is
essential to safe machine operation, good machine
performance and service life. Continued use of a
worn turntable bearing could create an unsafe
operating condition, resulting in death or serious
injury and component damage.
Note: Perform this procedure with the machine on a
firm, level surface and the boom in the stowed
position.
1 Grease the turntable bearing. See A-8, Grease
the Turntable Bearing and Rotate Gear.
2 Torque the turntable bearing bolts to
specification. See D-6, Check the Turntable
Rotation Bearing Bolts.
3 Start the machine from the ground controls and
raise the primary and secondary booms to full
height. Do not extend the primary boom.
CHECKLIST D PROCEDURES
1
15
7
12
4
5
14
9
2
16
8
3
11
6
13
10