Terex Genie Z-45/25 Bi-Energy, Руководство по обслуживанию

Страница: 121 / 213

Part No. 237062 Z-45/25 Bi-Energy • Z-45/25J Bi-Energy 5 - 3
September 2015 Section 5 • Fault Codes
Fault Code Chart
Continued on next page
Fault Code Programmer Condition Possible Causes Solution
Indicator The key switch or red Push in the ground control
LED is Communication Machine will Emergency Stop button(s) red Emergency Stop button
OFF or is Error not drive was cycled on and off faster to the OFF position and wait
ON but not than 5 seconds OR controller for 5 seconds. Pull out the
blinking sensed an internal error red Emergency Stop button
during start up. to the ON position. If problem
persist, replace the motor
controller.
01 Normal
operation
12 HW Failsafe Machine will The motor controller failed Replace the motor controller.
1-2-3 not drive self test.
13 M- shorted Machine will The motor controller has an Test the motor controller,
not drive internal short between refer to Repair Procedure
M- and B- terminals. 11-1.
Field open Machine will Drive motor wiring is loose Check for loose or open
not drive OR drive motor is defective connections at the drive
OR motor controller has an motors and motor controller
internal short. OR replace the defective
drive motor OR test the motor
controller. Refer to Repair
Procedure 11-1.
Arm sensor Machine will Defective motor controller. Replace the motor controller.
not drive
FLD sensor Machine will Defective motor controller. Replace the motor controller.
not drive