OPERATION
Boss 2000E (08–03)
9
To Install Deep Clean spray bar:
a.
Position spray bar in recessed area at top of
brush housing as shown (Figure 3).
b.
Connect quick coupler to spray bar.
FIG. 3
To Install Light Clean spray bar:
a.
From operators right side of machine, locate
unused quick coupler under machine at front.
b.
Connect unused quick coupler to spray bar.
c.
Align end of spray bar to spring loaded
bracket, located on chassis frame. Push
spray bar on bracket and position opposite
end to other bracket. Be certain that spray tips
are pointing towards rear of machine
(Figure 4).
LIGHT CLEAN
SPRAY BAR
SPRING LOADED
BRACKET
QUICK COUPLER
FIG. 4
4.
Fill solution bottles:
ATTENTION: Use Only recommended cleaning
solutions as listed below, DO NOT use substitutes.
S
FiberFresh UltraClean Extraction Detergent
S
FiberFresh Interim Extraction Cleaner
S
FiberFresh Foam Control Mixture
S
FiberFresh Quick Dri
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
a.
Fill solution bottles by following mixing
instructions on bottle.
b
Place bottles in bottle support rack (Figure 5).
FIG. 5
c. Connect red hose to FiberFresh UltraClean
bottle (Red label).
NOTE: Be certain to insert bottle hoses to bottom of
bottles.
d. Connect blue hose to FiberFresh Interim
Extraction cleaner bottle. Follow instructions
on bottle (bottle sold separately).
e. Connect clear hose to Foam Control Mixture
bottle.
5.
Transport machine to filling station: Your extractor
will glide easily across the floor by pushing
machine forward (without power). To pull machine
backwards, you simply pull reverse release lever
backwards and to the right to latch. This will allow
you to easily pull the machine backwards. Be
certain brush is raised before transporting. To raise
brush, pull brush lever backwards until it latches
(Figure 6).
FIG. 6
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
