OPERATION
20
Boss 2000E (08–03)
3. To remove defective spray bar, simply shift spray
bar to operators left side of machine and pull
down. (Figure 41)
LIGHT CLEAN
SPRAY BAR
SPRING LOADED
BRACKET
FIG. 41
4.
Disconnect coupler at spray bar top.
5.
Replace with spare spray bar, be certain to
position spray bar with spray tips facing forward.
To Clean Defective Spray Tips:
ATTENTION: DO NOT use pointed objects such as
pins and paper clips to unplug spray tips. This will
damage spray tips, causing improper spray
pattern and water flow through tips. Using
damaged spray tips will reduce maximum cleaning
performance. Follow proper unplugging
instructions below:
1.
Remove defective spray tips from spray bar. Take
note of spray tip position before removing.
2.
Pour 4 oz. of acetic acid (alkaline breakdown
chemical) into a small container.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
3.
Completely submerge spray tips and let soak for
up to six hours. Agitate spray tips occasionally.
4.
After soaking spray tips, use small brush to
remove excess alkaline and rinse thoroughly. DO
NOT use a pointed object to unplug spray tips.
5.
Replace spray tips in spray bar and keep on hand
for spare.
NOTE: If spray tips are damaged or cannot be
restored, replace spray tips. Be certain to use same
spray tip size and type. Improper spray tips will affect
cleaning performance.
TRANSPORTING MACHINE
When transporting the machine by use of trailer or
truck, be certain to follow tie–down procedures below:
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1.
Raise brush base.
2.
Load the machine using a recommended loading
ramp.
3.
Position the front of the machine up against the
front of the trailer or truck. Once machine is
positioned, lower the brush base and disengage
the reverse release lever.
4.
Place a block behind each drive wheel to prevent
machine from rolling.
5.
Place tie–down straps over the top of the machine
to prevent it from tipping. It may be necessary to
install tie–down brackets to the floor of your trailer
or truck.
FOR SAFETY: When transporting machine, use a
recommended ramp when loading/unloading
into/off truck or trailer, use tie–down straps to
secure machine to truck or trailer.
To Order Parts Call 1-888-702-5326 - https://monsterfloorequipmentparts.com
