How to Operate Your Instrument
To Set Display and Measurement Parameters
You adjust display parameters and measurement settings using soft key menus. Soft key menus appear at the bottom of
the display and for measurements, the settings apply to the active tile. For example, suppose you displayed a WFM
measurement in three tiles. The Sweep setting for each tile is set independently, so even though the soft key menu for
each tile would be identical.
1.
Select the tile whose parameters you
want to change by touching the tile (not
necessary in 1-View mode).
2.
Select the parameter you want to change
from the soft key menu.
3.
Some settings are accessed from the
Settings soft key.
Depending on the setting, you might need
to make selections from a submenu.
Some settings provide multiple choices
within the submenu. For example, when
selecting the components that are shown
in the WFM display, you choose from
all the available components within one
submenu.
NOTE.
The selections in a submenu can
change depending on settings.
To Select Among Video Inputs
You can connect serial digital component signals and select them for display in a tile. Depending on the model and options
that you ordered, you can connect standard-definition component signals, high-definition component signals and analog
composite signals.
To select a component input
1.
Connect any digital component video
signals to the A and B SDI inputs on the
rear panel.
NOTE.
The A and B inputs are separate
inputs and cannot be used as a loop-through
path.
Option Eye/Phy
26
Quick Start User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
