Technogym Vario Excite + 500, Руководство по техническому обслуживанию

Страница: 62 / 220

VARIO : Service & maintenance manual- rev. 4.2
Page 6.4
6.1.3.2. LED Test
The LED test checks the functioning of the display by lighting all the LEDs in the matrix. It also
tests the buzzer by changing the frequency to produce a variation in the tone of the sound.
There is no message displayed concerning the outcome of this test, which must therefore be checked
visually.
6.1.3.3. Serial Ports Test
The serial ports test checks the communications on the following interface ports:
•
C-Safe COM test;
•
Low Kit COM test;
•
TGS COM test.
Using the
+ and – effort level keys, select the desired test item and confirm by pressing ENTER .
The test can have two outcomes:
•
“Test Successful, press Enter to continue”: This means that the test was completed
successfully, i.e. that the communications on the selected serial port are functioning correctly.
•
“COMx error, press Enter to continue”: This means that the outcome of the test was negative:
the message will specify COM1 in the case of the C-Safe COM test, COM2 in the case of
communications with the low kit, or COM3 in the case of the TGS COM test.
The “TGS COM test” done on machine not provided with the key reader gives a fail
outcome. The same if the “C-Safe COM test” is done on a machine which C-Safe port
is not plugged with the monitor plug described at paragraph: 4.3. Monitor plug for C-
Safe port”.
6.1.4. M
ANUAL
T
EST
The tests grouped under this section conduct checks on the machine’s operation in a fully automatic
manner. After selecting the desired test using the
+ and – effort level keys, press ENTER to initiate
the test and then await the result. To exit test mode, press and hold down the CLEAR key for a few
seconds.
6.1.4.1. Man. Keyboard Test
The manual keyboard test checks the functioning of all the keys on the keyboard. After accessing
the test by pressing
ENTER , the message “ Press all buttons (beep=OK) ” appears on the display.
Pressing each key will produce an audible signal; if a key does not produce the beep it means it is
not working properly.