Technogym Vario Excite + 500, Руководство по техническому обслуживанию

Страница: 176 / 220

VARIO : Service & maintenance manual- rev. 4.2
Page 8.6
8.3.2. M
ACHINES WITHOUT SLOTTED PULLEY
For this operation it is necessary to disassemble the magnet group.
Figure 8.3-6
Carry out the procedures described in
paragraphs: 7.7. “Disassembling the guards”,
7.7.4. Swivel belt connector guard” and 7.16.2.
“Disassembling the magnet (Anti bottom dead
point)”.
1.
Stand on the pedal on the side being adjusted
and wait until it reaches its bottom dead
centre and the copper disk of the
electromagnetic brake has stopped, and then
get off the pedal.
2.
Align the moving handgrips, ensuring that
the pedal stays at its bottom dead centre.
3.
Back off ( or screw ) the adjusting pin (a) until
the distance (A) between: the upper surface
of the frame tube and the lower surface of the
swivel connector is 1000mm±1mm (39.4”),
see: Figure 8.3-7.
4.
Fix the adjustment by locking down the ring
(b) .
Continued on following page...