Technogym Vario Excite + 500, Руководство по техническому обслуживанию

Страница: 215 / 220

VARIO : Service & maintenance manual- rev. 4.2
Page 12.3
12.2. EXTRA-ORDINARY MAINTENANCE OPERATIONS
12.2.1. C
HECKING THE WORKING CONDITIONS
1. Check that the machine is connected directly to the wall outlet, without any extension cords, and
that the outlet is correctly earthed.
2. Using a multimeter, check that the machine earth node is correctly connected to earth.
12.2.2. C
HECKING THE OPERATION OF THE CARDIOTESTER RECEIVER
1. Using a separate heart rate monitor, put on the transmitter band and check that the machine and
the separate monitor both measure the same heart rate, and that when the band is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects variations in the heart rat.
12.2.3. C
HECKING THE OPERATION OF THE HAND SENSOR
1. Using a separate heart rate monitor, grasp the hand sensors and check that the machine and the
separate monitor both measure the same heart rate, and that when the sensors are released the
machine does not receive any signal.
12.2.4. C
HECKING THE STATE OF WEAR OF THE PEDAL LEVER BELT
1. Check the state of wear of the pedal lever belt, inspecting their entire length and. If any
anomalies are found, call in the authorized Technogym Technical Service.
12.2.5. C
HECKING THE AMOUNT OF PLAY ON THE BALL JOINTS
1. Check the amount of play on the ball joints. If any anomalies are found call in the authorized
Technogym Technical Service.
12.2.6. C
HECKING THE WEAR OF RUBBER PARTS
1. Check the state of wear of the rubber components. Replace if there are evident signs of wear.
12.2.7. C
HECKING THE BELTS
1. Check the state of wear of the belts, using the pulley to turn it by hand, paying special attention
to the edges and the inner part. Replace if there are evident signs of wear.
2. Also check the tension of the belts.
12.2.8. C
HECKING THE PLAY OF THE LEVER AND PEDAL GROUP
1. Choose a manual training session with difficulty level 1. Step onto the pedals and start using the
machine, moving the weight of your body backward and forward, to the right and left. Check
whether the lever and pedal group follows these shifts in body weight with an excessive amount
of play. If this is the case, replace the lever or pedal group.