Technogym Vario Excite + 500, Руководство по техническому обслуживанию

Страница: 155 / 220

VARIO : Service & maintenance manual- rev. 4.2
Page 7.55
7.16. DISASSEMBLING THE BELTS AND MAGNET
7.16.1. S
HORT BELT DISASSEMBLING
Figure 7.16-1
Carry out the procedure described in paragraph:
7.7.1. “Disassembling the centre guard”, 7.7.3.
7.7.4. “Swivel belt connector guard”.
1.
Use a chair or bench to raise the pedal levers,
so as to eliminate the tension from the belts,
as shown in the figure.
Figure 7.16-2
2. Cut the 2 cable ties (a) and remove the 2
half-guards (b) and (c) that prevent twisting
of the belt.
3.
Unscrew the swivel connector (d) using a
6mm hexagonal wrench, and holding the nut
on the opposite side in place with a 17mm
wrench, as shown in the figure.
CAUTION: During reassembly, take
care to re-insert the swivel connector
on the correct side: with the snap ring
toward the outside and the deeper
end, with its spacer, on the inside.
Figure 7.16-3
CAUTION: During reassembly, follow
the sequence indicated in the figure at
left.
Continued on following page...