Technogym Vario Excite + 500, Руководство по техническому обслуживанию

Страница: 147 / 220

VARIO : Service & maintenance manual- rev. 4.2
Page 7.47
Figure 7.14-5
9. Back off the screw (d) using a 13mm wrench
as shown in the figure.
ATTENTION: Take particular care
with the copper disk, as it bends easily
Figure 7.14-6
10. Back off the screw (e) , using two 13mm
wrenches, one inside the plate on the shaft
notch, and the other on the outside as shown
in the figure.
11.
Remove the flywheel.
Figure 7.14-7
To remove the copper disk, place the flywheel on
a work bench:
12.
Back off the 6 screws (f) using a 4mm
hexagonal wrench, and remove the copper
disk; replacing it if necessary.
CAUTION: During reassembly, lock
down the screws (f) using a torque
wrench setting of 6 Nm.
To reassemble the flywheel,
carry out the above steps in reverse order.