Technogym Vario Excite + 500, Руководство по техническому обслуживанию

Страница: 150 / 220

VARIO : Service & maintenance manual- rev. 4.2
Page 7.50
Figure 7.14-14
ATTENTION: Do NOT back off the
screw (
b ) under any circumstances, as
this is the unique reference for
reassembling the primary unit.
Figure 7.14-15
3. Back off the 4 screws (c) using an 8mm
hexagonal wrench, holding the nuts on the
opposite side in place with a 17mm wrench.
CAUTION: In case of the support
bearing is made of plastic and not iron
like in the picture, during reassembly,
lock down the screws (c) using a
torque wrench setting of 20 Nm.
Figure 7.14-16
4. Remove the primary unit (d) .
ATTENTION: It is not possible to
disassemble the connecting rods from
the pulley, because they are fixed with
Loctite.
To reassemble the primary unit, carry out the
above steps in reverse order.