Tatoma EMV-8, Инструкция по эксплуатации

Страница: 54 / 68

TOWED VERTICAL MIXER
•
Visually inspect the condition of the blades. If blade wear is not
excessive, sharpen them with an electric grinder. If wear is excessive,
the blades should be changed.
For safety reasons, blade maintenance or changes, for the
auger, should be performed by qualified TATOMA personnel.
Auger:
To carry out maintenance on the auger blades, it is necessary to enter the
inside of the tub. Enter the inside of the tub should be accessed using the
tub access ladder.
Personnel that enter the tub should shut down the machine
and keep the ignition keys in their possession for the whole
time that they are inside. They should also use the individual
protective equipment necessary to guarantee their safety.
Figure 4.14: View of Auger Blades
Steps that should be carried out to change the blades are:
-
Access the tub by the points previously indicated.
- Remove the screws.
- Rotate, sharpen or substitute the blade depending on its condition.
- Tighten the screws.
Clean the Inside of the Tub:
For cleaning the inside of tub, place the mixer on a sloping surface, so
that all the accumulated liquids drain from the unloading door that is opened
fully.
For safety reasons, the inside of the tub should be cleaned by
qualified TATOMA personnel.
4.9. UNLOADING BELT
Clean the Unloading Belt
In order for the belt to unload correctly and with optimal performance, it
should be completely unloaded each time it is used. To do this, close the
unloading door and leave the belt running until no mix remains.
Weekly, completely clean the unloading belt by removing its cover and
removing the accumulated mix remains.
Check and Adjust the Chain Tension
To adjust chain tension, tighten the tension screws on the bearings found
on both sides of the belt until the driveshaft is completely aligned.
Page 49