Tatoma EMV-8, Инструкция по эксплуатации

Страница: 33 / 68

HORIZONTAL TOWED MIXER
Do not approach the battery with a naked flame due to the
risk of explosion
Do not leave metal objects on the battery due to the risk of
electrical discharge should a short circuit be produced in
the battery terminals.
2.8 WEIGH SCALE
Figure 2.16 Weigh scale
Figure 2.17: Loading sensors
Before starting to handle the scale read
the instruction manual for the scale that is
supplied with the mixer carefully.
The scale (1) is situated on the front of
the mixer, on the right-hand side. It is
mounted on the inside of the protection
box (2) fitted with a polycarbonate front
and an articulated mechanism that allows it
to be moved to guarantee the visibility of
the display screen
The weighing system is fitted with three
loading sensors (4), situated on the tub
resting points, a connection box (5)
situated below the access ladder to the tub
and an acoustic indicator (3) situated in the
protection box of the scale, that warns of
the loading of each component of the
mixer.
The weigh scale is connected to the
battery of the tractor that tows the mixer.
Should the mixer be fitted with a battery
(Auxiliary battery connection), the scale is
directly connected to the latter, so that it
works at all times irrespective of the state
Figure 2.18: Connector
Fig. 2.21 Connection box
of the machine, enabling the mixer to be
loaded without being hooked up to the
tractor.
. For the weighing scale to work correctly
the following recommendations should be
taken into consideration:
•
Check that the battery is well
charged and its connections to the
battery are correct, the cables
should not be taut, pulled or have
any cuts or folds, which could
eventually cause them to break.
The voltage should not suffer
alterations of greater than ± 1 volt.
•
Avoid hitting of spilling liquids on
the screen. Similarly, reduce
speed when driving on roads
which are in bad condition with the
machine loaded, as the sensors
could suffer deterioration, giving
rise to defective weighing.
6
2
3 1
•
Should the fuse need to be
replaced use one with the same
intensity and disconnect the
battery before using it. Using
higher intensity fuses could
provoke surges in the weigh scale
circuit with the consequent
possibility of a breakdown.
5
4
•
Do not manipulate the sensors
under any condition; they should
only be handled by TATOMA
technical personnel.
Page 28