Tatoma EMV-8, Инструкция по эксплуатации

Страница: 23 / 68

TOWED VERTICAL MIXER
Door Type Unloading System (13/15): Based on the model and
option selected, this can be situated in the rear and on one or both
sides of the mixer. This has an unloading door, which is hydraulically
operated and can vary the opening through which the product is
unloaded, according to the needs of the dosing process. See figure
that follows.
Figure 1.7: Side and back discharge door DUPLO and single auger models
Access Ladder and Platform (6/24): This is situated in the front part
of the mixer. Its use is restricted to extraordinary circumstances when
working with the mixer. When accessing the tub, you must respect the
following recommendations
:
Keep the ladder steps clean and never jump on to the
floor from them as there is a danger of injury caused
by a slip or a fall.
Do not put any component, mechanism or system
that allows access to the tub above the height of the
platform
Keep the ladder steps clean and never jump to the
ground from them, as there is a danger of injury
caused by a possible slip or fall.
When accessing the tub, you must respect the following
recommendations
Do not, under any conditions, access the inside of the tub
while the machine is running. When carrying out
maintenance or repair work, the tub shall be accessed
exclusively by experienced personnel while the machine is
completely shut down, and the person entering the tub
should have the ignition key in his or her possession, and
the universal joint should be disconnected from the
tractor's power take off.
Trailer foot (5/23): This keeps the mixer in the appropriate position
while parked and/or being hooked up to the tractor. It is manually
operated, but a hydraulic option is also available.
Hydraulic System and Components: The hydraulic installation is
different from that of the tractor comprising a sprocket pump worked by
the tractor PTO through the cardan transmission and gear, this pump
aspirates the oil from a tank (7/27) situated at the front of the machine
and supplies oil to a single block distributor with cable controls or an
electrovalve block (3/19) worked by electric controls or via radio
(optional).
All the machine services can be worked by the block or the
distributor, with the unloading belt acting in conjunction with other
functions as it is has a serial connection.
The oil tank has a return filter with a rechargeable cartridge to ensure
circuit cleaning. It is also fitted with a filling cap. All the circuits available
in the mixer are independent and have been constructed using high
quality reliable components.
Control Block (2/20): The mixer has a remote control system made
up of levers and cables. Optionally, it can come with an electronic
button panel remote control or radio remote control.
Electric System: All circuits on the mixer and have been built using
high quality components that are very reliable. (Not shown)
Page 18