Tandberg Data MSERIES USER, Руководство пользователя, Страница: 98 / 190

Chapter 5 Running Diagnostic Programs
Running the Move Location Test
82 Tandberg Data M-Series User’s Guide
13
Press the
Up
and
Down
buttons to change the highlighted number.
14
Press
Left
to move the highlight to the next number.
15
Repeat steps 13 and 14 as necessary until the desired cycle count
number is displayed.
16
Press
Right
until the cursor is all the way to the right and the
Select
button appears.
17
Press
Select
to set the cycle count, or press
Cancel
to return to the
Diags: General
screen without running the
Move Medium
test.
The test starts and the GUI displays a
Running Diag
screen. The test
stops automatically after completing the selected number of cycles.
When the test is complete, the GUI displays a screen indicating the
test status.
To abort the test before it completes the selected number of cycles,
press
Stop
.
18
Press
Back
.
The GUI displays the cycle count screen.
19
Press
Cancel
, then
Back
to return to the
Diags: General
screen.
Running the Move Location Test
5
The
Move Location
test is similar to the
Move Medium
test, except that no
cartridges are actually moved.
When the
Move Location
test is cycled once, the robotic hand is moved
from its current location to the destination location.
When the
Move Location
test is cycled more than once, the robotic hand is
repeatedly moved between the destination location and a home location,
and will return to the home location at the end of the selected number of
Note:
Setting the cycle count to
0000
causes the test to run
continuously.