Tandberg Data MSERIES USER, Руководство пользователя, Страница: 100 / 190

Chapter 5 Running Diagnostic Programs
Running the Move Location Test
84 Tandberg Data M-Series User’s Guide
The GUI displays the
Diag: Move Location
screen, which prompts you
to set the cycle count (see figure 55 ). The rightmost number is
highlighted.
Figure 55 Diag: Move
Location Screen
8
Press the
Up
and
Down
buttons to change the highlighted number.
9
Press
Left
to move the highlight to the next number.
10
Repeat steps 8 and 9 as necessary until the desired cycle count
number is displayed.
11
Press
Right
until the cursor is all the way to the right and the
Select
button appears.
12
Press
Select
to set the cycle count, or press
Cancel
to return to the
Diags: General
screen without running the
Move Location
test.
The test starts and the GUI displays a
Running Diag
screen. The test
stops automatically after completing the selected number of cycles.
When the test is complete, the GUI displays a screen indicating the
test status.
To abort the test before it completes the selected number of cycles,
press
Stop
.
Note:
Setting the cycle count to
0000
causes the test to run
continuously.
Tandberg Data