DXF-200 Getting Started Guide
Page 20
Connecting the Environmental Module to the Pulse Source Module
1
Before making any connections, make sure the DXF is level.
2
Place the reflector in the location shown in the image below, and then install the sealing foam.
Figure 5
Reflector and sealing foam.
3
Place the Environmental Module on top of the DXF so that they are stacked; make sure to align the 4
pins on the bottom of the furnace with the corresponding holes on the alignment tracks on the top of the
DXF.
Figure 6
Pins on the bottom of the Environmental Module.
Reflector
Alignment Tracks
Alignment Pins
Sealing Foam
