DXF-200 Getting Started Guide
Page 22
DXF Back Panel
The table below provides a description of the function of each port/cable on the DXF back panel. Refer to
for an illustration of rear connections. Ports not described and not labeled are not used.
Table 6:
DXF Back Panel Ports and Functions
Port
Function
J101 Port
Connects the Beam Mapping Board to the Data Acquisition
Board
J102 Port
Connects the Pins Amplifier Board to the Data Acquisition
Board, providing communication between the DXF and the
Solid State Detector Assembly
USB Cable
Provides flash control
USB1 Cable
Provides data acquisition
TEMPERATURE CONTROLLER
COMMUNICATION Cable
Provides communication between the temperature controllers
and the controller
SYSTEM POWER
SYSTEM POWER PLUG provides power to the EM and
SYSTEM POWER SWITCH powers the DXF off (
O
) / on (
I
)
LED indicators
6 green LED indicators indicate system readiness. From left
to right:
1
+12 Volts Analog Power Supply
2
+12 Volts Analog Power Supply
3
+12 Volts Digital Power Supply
4
+12 Volts Communications Power Supply
5
Filter Output 2 – not used on this instrument
6
Filter Output 1 – not used on this instrument
