FLANGING MACHINE
59
F-200
7.2 THE WORK CYCLE OF THE COLD FLANGING AND FLARING
1. Choose the correct forming pin and install it.
2. Fasten the pipe. Place the pipe to the clamp so that the pipe end is against the forming
pin. Close the clamp. Be careful that the pipe clamp doesn’t collide with the forming
head.
3. Carry out the settings of the forming tool and flanging unit, and select suitable program
from display.
L
DANGER! Before starting the automatic work cycle, make sure that the pipe
has been clamped properly.
L
DANGER! If the spindle does not rotate evenly or it stops, interrupt the work
cycle immediately by pressing the EMERGENCY STOP button completely down.
4. Press the “CYCLE START”
push-button. The machine will perform an automatic
work cycle. When the work cycle is finished, the spindle will stop in its correct position -
ready for the following work cycle to be carried out.
NOTE!
¨
After flanging the pipe end may be hot.
5. Loosen the flanged pipe, inspect its measures and if unsatisfactory, make the necessary
corrections in the set values.
