INSTRUCTION MANUAL
34
6. Turn the key switch to the MANUAL position “2”.
NOTE!
¨
The brake is released when the brake release push-button
is pressed
down. The brake is engaged again when the push-button is released.
7. Open the hood.
8. Press the
push-button down, which will release the brake.
NOTE!
¨
Be careful when turning the forming pin, because it has the tendency to
turn backwards, due to its eccentric mass
9. Turn the forming device to its horizontal position, the adjustment unit will then point
to the side. Lock the forming device by releasing the brake push-button.
10. Turn the key switch to the position “0”.
11. Block the rotary movement of the forming pin by means of a 6mm allen key and
loosen the 8mm hexagon socket screw, which is behind the pin.
12. If the forming pin does not easily come out of its housing, knock on the hexagon
socket screw head with a hammer (the hexagon socket screw has not been removed
completely, but is screwed sufficiently inside).
13. Check, that the forming pin and chuck are clean, and the forming pin is fitted in its
place and that it turns smoothly when turning it manually.
