T-Drill F-200, Инструкция по эксплуатации

Страница: 43 / 98

FLANGING MACHINE
43
F-200
6.3.6 THE SETTING GAUGE OF THE PIPE
The setting gauge of the pipe is used for regulating the protrusion of the pipe from the
end of the clamp (measure B) when expansion, flaring or beveling of the pipe end is to be
carried out. When the measure A (the length of the clamp) or B change, the setting gauge
is to be adjusted again.
Protrusion B of the pipe:
Expansion ≤ 35mm
Beveling 12-15mm
Flaring max. 50mm
B
1
2
A
3
4
The setting gauge of the pipe: 1. Pipe clamp, 2. Wing screw, 3. Slide piece,
4. Setting gauge of the pipe
1. Open the clamping jaws and press the stop push-button .
2. Set the measures A+B on the setting gauge and tighten the wing screw
3. Put the setting gauge on the pipe clamp edge so, that the slide piece is against the
outer edge of the clamp.
4. Insert the pipe to be formed into the clamp and push it against the end of the setting
gauge.
5. Remove the setting gauge.