FLANGING MACHINE
39
F-200
1. Start the machine by pressing the power on push-button
.
2. Select the forming type, the way of forming and the flanging mode by means of the
selector switches in accordance with the desired automatic work cycle, for instance cold
flanging:
Normal flanging.
Cold forming. (If you have heating unit)
1 phase flanging.
3. Close the clamps by turning the clamp control
switch (clamps close) in order to
pressurize the hydraulics. Keep the control device in this position until the clamps are
closed.
4. Drive the frame to back position by turning the
switch (clamps close) and turning
at the same time the control switch of the frame to the position
.
5. Remove the locking pins of the pipe clamps and open the clamps by turning the
switch (clamps open).
6. Stop the machine by pressing the power off push-button
.
NOTE!
¨
Always use protective gloves when handling the pipe clamps.
7. Remove the previous pipe clamps and install clamps of the required dimension
according to the pipe in the guides of the jaws.
Installation of the pipe clamp or clamp adapter: 1. Locking pins, 2. Pipe clamps, 3. Clamp
jaws.
