FLANGING MACHINE
57
F-200
9. Stop the machine and push the protective hood backwards.
10. Digital measure device indicates the real distance of the forming pin from center of the
pipe (= radius 2.5).
Adjust the turning radius wanted of the forming pin by turning the eccentric sleeve. As
turning radius you can select a value between 2,5…7,5mm.
1. Zero point
The diameter graduation compensation of the forming pin according to the turning radius:
when the eccentric sleeve is turned in the direction of the smaller radius, the value of the
digital reader is to be decreased correspondingly. If the eccentric sleeve is turned in the
direction of the bigger radius, this value is to be increased correspondingly.
Adjust the slide in such way, that the forming pin just touches
the inner surface of the pipe. Tighten the locking screw.
Adjust the slide in such way, that the distance between the
forming pin and the inner surface of the pipe is about 1 mm.
Tighten the locking screw.
11. Close the protective hood and start the machine.
12. Drive the frame to its rear position by turning the clamp control switch , at the same
time turning the control switch of the frame into the position
.
13. Open the clamping jaws and remove the pipe.
14. Close the clamping jaws.
