Swatch Lasag SLS 200 CL Series, Инструкция по эксплуатации

Страница: 124 / 347

I N D U S T R I A L - L A S E R S
A COMPANY OF THE
I N D U S T R I A L - L A S E R S
A COMPANY OF THE
© Lasag AG, Thun, 26.02.08 CM
Service instructions
Laser sources
6 Error messages
86 . 0621 - 06 - 16
6.4 Error messages L = Limits
Bit
No.
Message text
Signal
Significance Measures
L 00
Max IP/SP
Integ/system parameter larger than permitted Enter new value in operating range
L 01
Min IP/SP
Integ/system parameter smaller than permitted Enter new value in operating range
L 02
Max recipe
Value larger than max. in recipe PS Enter new value in operating range
L 03
Min recipe
Value smaller than min. in recipe PS Enter new value in operating range
L 04
Param. 1
Parameter 1 off limits Enter new value in operating range
L 05
Param. 2
Parameter 2 off limits Enter new value in operating range
L 06
no choice
Change is blocked in recipe PS Release changeover in recipe and
select recipe again for WPS
L 07 Address outside the permitted range Request values again, Check range
L 10
f > fmax
Frequency larger than max. frequency in SP Enter new value in operating range
L 11
t > tmax
Pulse duration larger than maximum in SP Enter new value in operating range
L 12
U < Umin
Voltage smaller than minimum voltage in SP Enter new value in operating range
L 13
U > Umax
Voltage larger than maximum voltage in SP Enter new value in operating range
L 14
f > Pmax
Frequency too large for max. energy in SP Enter new value in operating range
L 15
t > Pmax
Pulse duration too large for max. energy in SP Enter new value in operating range
L 16
U > Pmax
Voltage too large for max. energy in SP Enter new value in operating range
L 17
f > GSS
Frequency too large for GSS in SP Enter new value in operating range
L 18
t > GSS
Pulse duration too large for GSS in SP Enter new value in operating range
L 19
U > GSS
Voltage too large for GSS in SP Enter new value in operating range
L 20
t > Emax
Pulse duration too large for max. energy in SP Enter new value in operating range
L 21
U > Emax
Voltage too large for max. energy in SP Enter new value in operating range
L 22
f > Duty c
Frequency too large for duty cycle in SP Enter new value in operating range
L 23
t > Duty c
Pulse duration too large for duty cycle in SP Enter new value in operating range
L 24
td+tEMWInc
+t > T
Delay+pulse duration > periode=1/f Enter new value in operating range
L 25
f<fmin ALT
Frequency to small for alternating Change to a other mode
L 26
P < Pmin
Power setting smaller than permitted in SP Enter new value
L 27
P > Pmax
Address outside the permitted range Request values again, check range