Svantek SVAN 106, Руководство пользователя

Страница: 28 / 97

SVAN 106 User MANUAL
_
28
Setting time delay before the start of measurements
The Start Delay defines the delay period from the <Start/Stop> push-
button pressing to the start of the measurements (the digital filters of the
instrument analyse constantly the input signal even when the
measurements are stopped). This delay period can be set from 0 second to
60 seconds (with 1 second step by means of the <
3 3 3 3
>, <
4 4 4 4
> push-buttons
and with 10 seconds step with the <
3 3 3 3
>, <
4 4 4 4
> push-buttons pressed
together with the <Shift> one.
Notice: The minimum delay period is equal to 0 second. In the Calibration mode, the delay
period is equal to 5 seconds.
Setting the integration period
The Measure Period defines the period in
which the signal is being averaged during the
measurements. The
definitions of the
measurement results in which the integration
period is used is given in App. D.
<
4 4 4 4
>
The required value of this parameter can be set in the range of:
- from 1 s to 59 s (with 1 second or 10 seconds step),
from 1 m (min) to 59 m (with 1 minute or 10 minutes step),
- from 1 h to 24 h (with 1 hour or 10 hours step).
It is also possible to set Inf value. The Inf value denotes the infinite integration of the measurements (until
the pressing the <Start/Stop> push-button or after receiving the remote control code).
Additionally, the predefined periods: 1 m, 5 m, 15 m, 1 h, 8 h, 24 h and Inf, which are enumerated in the
standards, are also available (by pressing the <
3
3 3
3
> push-button or <
3
3 3
3
> with <Shift>; these values are
placed in the mentioned above sequence on the left in relation to 1 s).
Notice: In the case of switching on the Auto Save function, the minimum value of the
integration period should be equal to 10 seconds.
If the user wants to switch on Auto Save option (path: Menu / File /
Save Options) the integration period value has to be greater or equal than
10 seconds. When Auto Save option was switched on and new entered
integration period value is less than 10 seconds Auto Save option switches
off and Integration Period Too Short / Autosave Not Available message
appears on the display.