Svantek SV 104BIS, Руководство пользователя

Страница: 36 / 180

36
SV 104BIS User Manual
4.4 B
ATTERY CHECK
Observe the battery icon in the instrument’s icon status
bar or press the key until the Instrument Status
view mode is presented and check the battery state. If it is too low, charge the batteries (Chapter 4.1 ).
Figure 4-3 Instrument Status - Battery state
Battery status screen is moved down and up with the and keys.
Press to change to the next VIEW mode.
Note: Battery state of charge calculation is based on internal charge counter and should be
considered only as an overall, not very precise estimation. Therefore, the time left could be
noticeably different. Although the newest technology cells are used the slight degradation over time
is inevitable thus aging requires occasionally factory based (or authorised service centre)
replacement of the rechargeable battery cells.
Note: Battery power indicator - To improve accuracy of remaining battery life indicator, run the
dosimeter until it is fully discharged; then proceed with a full charge via docking station.
The procedure is recommended before first use. Repeat this procedure every few months of use
to maintain more accurate current battery condition indication.
4.5 R
EVIEWING UNIT LABEL
Unit label screen provides information about elementary dosimeter properties such as:
•
Copyrighted manufacturer name: SVANTEK (C)
•
Instrument name: SV 104BIS
•
Unit serial number: SN XXXXX
•
ST 104B microphone serial number: SN ST104B XXXXX
•
Unit name: XXXXXXX [user programmable name]
•
Firmware version: Version X.XX.X
•
File system version: FS Version X.XX
•
CRC value: CRC(OK) XXXX
•
Standards list, that the dosimeter conforms to:
o
IEC 61252:2020
o
ANSI S1.25:1991 (R2017)
o
Class 2: IEC 61672-1:2013
o
Class 1: IEC 61260-1:2014
To access the Unit Label screen short press altogether three keys: , and at the same time.