Svantek SV 104BIS, Руководство пользователя

Страница: 68 / 180

68
SV 104BIS User Manual
The timer can be switched off
“Off”
or switched on
“
On
”
.
In case the timer function is active ( On ) and the instrument is switched on the Time screen appears until the
programmed measurement runs are finished.
The Start (hh:mm) and Stop (hh:mm) positions determines the time for the measurement to start and to stop
automatically. The required hour and minute should be selected.
The Day of week determines the days in a week when the measurements should start. The timer can be
programmed ( Max. no. of measurement days
) up
to 100 days ahead or without limitation ( Inf ) and during
these
days’
settings of the current state of the R eal T ime C lock is taken into account. Make sure to check that
the real-time clock settings for the measurement location are correct before beginning a delayed timer
measurement.
6.3.11 Recording options
Recording tap has two panels
–
Event Recording and Wave Recording . For SV 104BIS only the
Wave Recording option is available.
Note: The Wave Recording is an optional function and should be activated before use. Activation
of the optional functions can be made with the use of the Supervisor software
–
see Chapter 6.2 .
6.3.11.1 Wave recording configuration
In the
Wave Recording
panel, you can configure an audio signal recording in a separate *.wav type file. For
this purpose, select the Recording Mode other than Off : Continuous , Trigger Slope +, Trigger Slope -,
Trigger Level + or Trigger Level - . These modes require different sets of parameters and use different ways
of signal recording (triggering) which are described below.
Figure 6-22 Wave recording configuration panels