Suzuki SFV650, Руководство по обслуживанию

Страница: 446 / 573

4A-10 Brake Control System and Diagnosis:
Front Brake Master Cylinder Assembly Removal
and Installation
B944H14106011
Removal
1) Remove the right rear view mirror (1).
2) Drain brake fluid. Refer to “Brake Fluid Replacement
(Page 4A-6)”.
3) Disconnect the front brake light switch lead coupler
(2).
4) Place a clean rag underneath the brake hose union
bolt (3) on the master cylinder to catch any spilt
brake fluid.
CAUTION
!
The brake fluid reacts chemically with paint,
plastics, rubber materials, etc., and will
damage them severely.
5) Remove the brake hose union bolt (3) and
disconnect the brake hose.
6) Remove the master cylinder holder bolts (4).
Installation
Install the front brake master cylinder in the reverse
order of removal. Pay attention to the following points:
• When installing the master cylinder (1) onto the
handlebars (2), align the master cylinder holder’s
mating surface “A” with the punch mark “B” on the
handlebars (2) and tighten the upper holder bolt first.
Tightening torque
Master cylinder holder bolt (Upper and Lower)
(a): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
• After setting the brake hose union to the stopper,
tighten the union bolt to the specified torque.
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
Tightening torque
Brake hose union bolt (b): 23 N·m (2.3 kgf-m, 16.5
lbf-ft)
• Bleed air from the brake system. Refer to “Air
Bleeding from Brake Fluid Circuit (Page 4A-5)”.
1
2
3
4
I944H1410020-02
“C”: Up mark “a”: Clearance
1
2
“C”
“A”
“B”
(a)
I944H1410021-01
1
“B”
“ a ”
2
(a)
“A”
“C”
I944H1410037-01
(b)
I944H1410038-01