Suzuki SFV650, Руководство по обслуживанию

Страница: 430 / 573

3A-8 Drive Chain / Drive Train / Drive Shaft:
NOTE
The tip of pin remover (7) should be
positioned inside “a” approximately 5 mm
(0.2 in) from the end face of pressure bolt [A]
(3) as shown in the illustration.
2) Place the drive chain link being disjointed on the
holder part (8) of the tool.
3) Turn in both the adjuster bolt (6) and pressure bolt
[A] (3) so that each of their end hole fits over the
chain joint pin properly.
4) Tighten the pressure bolt [A] (3) with the bar.
5) Turn in the pressure bolt [B] (4) with the bar (5) and
force out the drive chain joint pin (9).
CAUTION
!
Continue turning in the pressure bolt [B] (4)
until the joint pin has been completely
pushed out of the chain.
NOTE
After the joint pin (9) is removed, loosen the
pressure bolt [B] (4) and then pressure bolt
[A] (3).
6) Remove the joint pin (9) of the other side of joint
plate.
CAUTION
!
Never reuse joint pins, O-rings and plates.
Drive Chain Connecting
WARNING
!
Do not use joint clip type of drive chain. The
joint clip may have a chance to drop which
may cause severe damage to motorcycle and
severe injury.
Joint plate installation
1) Set up the special tool as shown in the illustration.
“a”: 5 mm (0.2 in)
3
7
“ a ”
I944H1310026-01
3
6
8
I718H1310032-01
1. Tool body
2. Grip handle
3. Joint plate holder (Engraved mark “F520”)
4. Wedge holder and wedge pin
5. Adjuster bolt (Without hole)
6. Pressure bolt [A]
7. Bar
4
5
I649G1310027-02
3
4
6 7 9
I649G1310028-02
1
2
3
4
5
6
7
(F520)
I944H1310027-02