Suzuki SFV650, Руководство по обслуживанию

Страница: 340 / 573

1I-2 Starting System:
Starter Motor will not Run
B944H11904002
NOTE
Make sure the fuses are not blown and the battery is fully-charged before diagnosing.
Troubleshooting
Starter Motor Runs but Does not Crank the Engine
B944H11904003
The starter motor runs when the transmission is in neutral with the side-stand up or down, but does not run when the
transmission is in any position other than neutral, with the side-stand up.
Step Action Yes No
1 1) Shift the transmission into neutral.
2) Grasp the clutch lever, turn on the ignition switch with
the engine stop switch in the “RUN” position and listen
for a click from the starter relay when the starter button is
pushed.
Is a click sound heard?
Go to Step 2. Go to Step 3.
2 Check if the starter motor runs when its terminal is
connected to the battery (+) terminal. (Do not use thin “wire”
because a large amount of current flows.)
Does the starter motor run?
• Faulty starter relay.
• Loose or
disconnected starter
motor lead wire.
• Loose or
disconnected
between starter relay
and battery (+)
terminal.
Faulty starter motor.
3 Measure the starter relay voltage at the starter relay
connectors (between B/Y (+) and Y/G (–)) when the starter
button is pushed.
Is the voltage OK?
Go to Step 4. • Faulty ignition switch.
• Faulty engine stop
switch.
• Faulty clutch lever
position switch.
• Faulty gear position
switch.
• Faulty turn signal/
side-stand relay.
• Faulty starter button.
• Faulty side-stand
switch.
• Poor contact of
connector.
• Open circuit in wire
harness.
4 Check the starter relay. Refer to “Starter Relay Inspection
(Page 1I-7)”.
Is the starter relay OK?
Poor contact of the
starter relay. Faulty starter relay.
Step Action Yes No
1 Check the side-stand switch. Refer to “Side-stand / Ignition
Interlock System Parts Inspection (Page 1I-8)”.
Is the side-stand switch OK?
Go to Step 2. Faulty side-stand
switch.
2 Check the starter clutch. Refer to “Starter Clutch Inspection
(Page 1I-12)”.
Is the starter clutch OK?
• Open circuit in wire
harness.
• Poor contact of
connector.
Faulty starter clutch.