Suzuki SFV650, Руководство по обслуживанию

Страница: 347 / 573

Starting System: 1I-9
Side-stand relay
1) Remove the turn signal/side-stand relay. Refer to
“Turn Signal / Side-stand Relay Removal and
Installation (Page 1I-8)”.
2) Check the insulation between “D” and “E” terminals
using the multi-circuit tester.
3) Apply 12 V to terminals “D” and “C” ((+) to “D” and (–
) to “C”) and check the continuity between “D” and
“E”. If there is no continuity, replace the turn signal/
side-stand relay with a new one. Refer to “Turn
Signal / Side-stand Relay Removal and Installation
(Page 1I-8)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test (
)
4) Install the turn signal/side-stand relay. Refer to “Turn
Signal / Side-stand Relay Removal and Installation
(Page 1I-8)”.
Diode inspection
1) Remove the turn signal/side-stand relay. Refer to
“Turn Signal / Side-stand Relay Removal and
Installation (Page 1I-8)”.
2) Measure the voltage between the “A”, “B” and “C”
terminals using the multi-circuit tester.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test (
)
NOTE
If the multi circuit tester reads 1.4 V and
below when the tester probes are not
connected, replace tester battery.
3) Install the turn signal/side-stand relay. Refer to “Turn
Signal / Side-stand Relay Removal and Installation
(Page 1I-8)”.
Gear Position Switch
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-
7)”.
2) Disconnect the gear position switch coupler (1).
CAUTION
!
When disconnecting and connecting the gear
position switch coupler, make sure to turn off
the ignition switch, or electronic parts may
get damaged.
DIODE
SIDE-STAND RELAY
TURN
SIGNAL
RELAY
“A” “B” “C” “D”
“E” “F” “G”
“A” “B” “C” “D” “E” “F” “G”
I649G1190028-02
“A”
“B” “C” “A”
“B”
“C”
I649G1190029-02
+
Probe of tester to:
“A”
“A” “C” “B”,
“C” “B”,
– 0.4 0.6 V
1.4 V and more
(Tester's battery voltage)
-
Probe of
tester to:
I649G1190046-04
1
I944H1190022-01