Sungrow Logger1000, Руководство пользователя

Страница: 49 / 94

39
7.7.3.2 Batch setting
step 1 Select the desired Country (region) and Grid type .
step 2 Click Configure Synchronization .
step 3 Select the desired devices in the pop-up device list, and click Save to achieve batch setting.
- - End
7.7.4 Protection Parameter
Click Device monitoring→Protection Parameters to enter the corresponding interface
and set protection parameters.
Protection parameters can be set in two manners: single setting and batch setting. For
specific setting method, refer to " 7.7.3 Initial Parameter " .
7.7.5 General Parameter
step 1 Click Device monitoring→General Parameters to enter the corresponding interface and
set general parameters.
step 2 Select Read-back , set Register Address , Register Number , and Address Type , and click
the button Read-back , to read the current value of the device.
step 3 Select Settings , set Register Address , Data Type , and set Value , and click the button
Save . Parameters can be set for a single device.
For parameters that need to be set, refer to corresponding communication
protocol of the inverter.
step 4 (Optional) Select Settings , set the Register Address , " Data Type " and set Value , and
Click Configure Synchronization . In the pop-up list of devices, check the devices that
need to be set, and click Save . You can set the parameters for multiple devices.
- - End
7.7.6 Device Instruction
Click Device Monitoring→Device Instruction to enter the corresponding interface.
On this interface, users can boot/shutdown the device or reset all settings.
Device instruction can be set in two manners: single setting and batch setting. Take the boot
operation as an example for explanation.
7.7.6.1 Single setting
step 1 Select a device, click Boot , and a dialog box pops up.
step 2 Click Yes to start a single device.
- - End
User Manual 7 WEB Interface