Sun Microsystems StorEdge 3000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 60 / 318

4-6 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • March 2004
Management is in-band through fibre host connections and out-of-band through the
serial port and Ethernet port on the back of each controller.
4.3 Connecting the Chassis to an AC Power
Outlet
When you connect the AC power cords, you should install the provided two cord
locks at the same time. The provided AC cord locks are used to securely fasten the
AC cable connectors.
Caution – If the array is connected to AC power sources not within the designated
90–135, 180–265 VAC PFC range, damage might occur to the unit.
Note –
To ensure power redundancy, be sure to connect the two power supply
modules to two separate circuits (for example, one commercial circuit and one UPS).
To connect the AC power cords, perform the following procedure:
1. Obtain an appropriate AC power cable.
2. Use a screwdriver to remove the screw and cylindrical standoff from one of the
two cord locks provided and set them aside for reassembly later.
3. Slide the cord lock over the AC power connector.
4. Hold the cylindrical standoff between the two screw-holes on the flanges of the
cord lock.
5. Insert the screw into the first screw-hole, through the standoff, and then into the
threaded screw-hole on the other flange.
6. Tighten the screw with a screwdriver
until the flanges bottom out on the
cylindrical standoff.
7. Push the power cord into the power supply receptacle until it is firmly seated.
8. Push the green ejector handle forward until it is seated against the power supply.
9. Turn the thumbscrew of the green ejector handle clockwise until it is finger-tight
to secure the handle and the cord lock.