Sun Microsystems StorEdge 3000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 154 / 318

7-6 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • March 2004
2. Depending on whether the cause of the alarm is a failed component or a controller
event and which application you are using, silence the alarm as specified in the
following table.
Note – Pushing the Reset button has no effect on controller event alarms and
muting the beeper has no effect on failed component alarms.
7.3 Deleting Logical Drives
To assign a different RAID level or a different set of drives to a logical drive, you
must unmap and delete the logical drive, and then create a new logical drive.
Caution – This operation erases all data on the logical drive. Therefore, if any data
exists on the logical drive, it must be copied to another location before deleting the
current logical drive.
Note – You can delete a logical drive only if it has first been unmapped.
To first unmap and then delete a logical drive, perform the following steps:
TABLE 7-3
Silencing the Alarm
Cause of Alarm To Silence Alarm
Firmware Application Sun StorEdge
Configuration Service Command-Line Interface
Failed Component
Alarms Use a paperclip to push the Reset button on the right ear of the array.
Controller Event Alarms From the Main Menu,
choose “system Func-
tions
→
Mute beeper.”
Refer to the Sun StorEdge
3000 Family RAID Firm-
ware User’s Guide
fore
more information.
Refer to “Updating the
Configuration” in the
Sun StorEdge
Configuration Service
User’s Guide
for
information about the
“Mute beeper”
command.
Run
mute
[controller].
Refer to the Sun StorEdge
3000 Family CLI User’s
Guide
for more
information.