Sun Microsystems StorEdge 3000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 272 / 318

H-2 Sun StorEdge 3000 Family Installation, Operation, and Service Manual • March 2004
To access the controller firmware through the serial port, perform the following
steps:
1. You must use a null modem cable to communicate via the serial port of the array.
Connect the serial null modem cable to the array and to ttyS0 (Com1), ttyS1
(Com2), ttyS2 (Com3), or ttyS3 (Com4).
Note – A DB-9-to-DB-25 serial cable adapter is included in your package contents to
connect the serial cable to a DB-25 serial port on your host if you do not have a DB-
9 serial port.
2. Power on the array.
3. After the array is powered up, power on the Linux server, and log in as root (or log
in as su if you logged in as a user).
4. Open a terminal session and type:
Press Return. You see the setup menu, where you define which serial ports to use,
baud rate, hand shake settings, and flow control.
5. Set the serial port parameters on the server.
See “Configuring a COM Port to Connect to a RAID Array” on page 4-14 for the
parameters to use.
a. At the configuration screen, highlight Serial Port Settings using the arrow keys
and press Return.
b. If A is not correct, press the letter A and the cursor goes to line
A
.
Backspace and edit:
where x is the proper serial port connecting the server to the array.
After you edit the line, press Return and the cursor goes back to the line
Change
which Settings?
minicom -s
/dev/ttyS( x )