Sun Microsystems StorEdge 3000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 227 / 318

Appendix B Using Standalone JBOD Arrays B-13
B.7.4 Connecting the Sun StorEdge 3510 FC JBOD
Array to a Host Computer
Use fiber-optic cables to connect one or two HBA ports on the host computer to the
Sun StorEdge 3510 FC JBOD array, as shown in the previous examples.
1. Connect a fiber-optic cable to an HBA.
2. Set your loop IDs using the ID switch on the JBOD array.
3. Connect the SFP connector at the other end of each of these fiber-optic cables to
host channel SFP connectors on the back of the JBOD array.
4. Power up the equipment in the following order, so that the host computer
discovers all connected arrays:
a. Sun StorEdge 3510 FC JBOD arrays
b. Host computer
5. Use your host system disk management utilities to prepare the disks in the Sun
StorEdge 3510 FC JBOD array for use.
Refer to your host system documentation for more information about disk
management utilities available to you.
B.8 Enabling Sun StorEdge 3510 FC JBOD
Array Support
For Sun StorEdge 3510 FC JBOD arrays, use JBOD support only when you have a
JBOD array connected directly to a host. This enables you to monitor peripheral
device condition and events. If you have an expansion unit connected to a RAID
array, the RAID controllers monitor the expansion unit’s condition and events for
you.
Note –
Enabling JBOD support can impact I/O performance.
To monitor peripheral device condition and events of a Sun StorEdge 3510 FC JBOD
array from the Sun StorEdge Configuration Service console, you first need to enable
JBOD support.
1. Choose View
→
Agent Options Management.
The Agent Options Management window is displayed.