Sun Microsystems StorEdge 3000 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 295 / 318

Appendix J Configuring an HP Server Running the HP-UX Operating Environment J-5
Note – To return to the Kermit prompt, type Ctrl \ and then C. To exit Kermit, first
return to the Kermit prompt and then type
exit
.
J.3 Attaching the Disk Array
The simplest way to configure a disk array is to use System Administration Manager
(SAM), HP-UX’s system administration tool. If SAM is not installed on your system,
or if you prefer to use the command-line interface, the following procedures guide
you through the task. For more information please consult the HP document,
Configuring HP-UX for Peripherals :
1. Use the
ioscan
command to determine what addresses are available on the HBA
to which you will be attaching the Sun StorEdge 3510 FC Array.
2. Access the firmware application on the Sun StorEdge 3510 FC Array and set the
SCSI IDs of the host channels you will be using.
3. Map the partitions containing storage that you want to use to the appropriate host
channels.
Partitions must be assigned to LUNs in sequential order, beginning at LUN 0.
4. Halt the operating system using the
shutdown
command.
5. Turn off all power to peripheral devices and then to the server.
6. Attach one or more host channels of the Sun StorEdge 3510 FC Array to the SCSI
interface cards in the host using the supplied SCSI cables.
7. Turn on the power to the Sun StorEdge 3510 disk array and all other peripheral
devices. After they are initialized, power on the server and boot HP-UX. During
the boot process, the operating system recognizes the new disk devices and builds
device files for them.
8. Verify that you can see the new storage resources by running the
ioscan
command. You are now ready to use the storage.
Note – If you create and map new partitions to the array, you can have them
recognized by the operating system without rebooting. Run the
ioscan
and the
insf
commands to discover the resources and to create their device files.