S
ettiNGS
A series of parameters needs to be defined within the guid-
ance bar to enable it to operate in tune with both the Stop
& Go unit and the actual state of the centrifugal fertiliser
spreading.
- First set all the distances relating to the positioning of
the GPS antenna on the tractor roof.
- Always position the antenna the same distance from the
spreader if you change your tractor (see distance X1 and
Y1 on the distance settings diagram opposite).
- Specify a machine comprising 2 boom sections.
- Make sure you correctly configure the use of the sections
that have been connected.
(preferably numbers 1 and 2).
The overlap rate indicates the point when the system will
stop spreading when it encounters an area where fertiliser
has already been spread.
Note that the higher this value, the lower the risk of gaps in
the coverage.
Conversely, a low value contributes to limiting over-applica-
tion in the field.
Depending on the overlap rate used, the type of guidance
system and the boom section control system in your posses-
sion, it may be normal to see small white areas on the field
display that correspond to where spreading stopped shortly
(recurring small areas in the field).
However, because of the way in which a Sulky fertiliser
spreader functions by multi-overlap, these areas may in fact
prove to have a density close to the average application rate.
(Info-Traçabilité) Modification sulky 00 vers 01
Directives pour TRADUCTION SE
À AJOUTER ou À TRADUIRE
À SUPPRIMER
À VÉRIFIER
60
61
GB
SE
Programming / Programmering
Programming / Programmering
2
G
G
G
