Sturtevant Richmont 10191, Руководство пользователя

Страница: 14 / 51

Mounting to Selected Support
Once the installation location has been determined, the actual installation process can begin.
1. Place your
Torq-Tronics ®
in the selected mounting location, supported as necessary to
assure stability of the location and safety.
2. Mark the location of the mounting holes on the surface to which the tester is to be
mounted.
3. Remove the
Torq-Tronics ®
from the installation location, and drill or drill and tap
mounting holes.
4. Your
Torq-Tronics ®
may be mounted with bolts and nuts or with bolts into a drilled
and tapped hole. Regardless of method, the
Torq-Tronics ®
is designed to be mounted
with 3/8" (or metric equivalent) diameter bolts. Bolts should be at least SAE Grade 5,
with SAE Grade 8 preferred. Drill, and if necessary, tap the holes.
5. Place the
Torq-Tronics ®
over the holes and install the bolts, and if necessary, nuts.
Check to insure that the tester does not move after the fasteners have been installed.
Electrical Connection
1. The first step in providing power is installation of the four (4) AA NiCd batteries.
a. Remove the two Phillips head screws holding the battery cover in place on the right
side of the
Torq-Tronics
® unit. Use a #1 Phillips screwdriver.
b. Gently remove the battery cover and attached battery pack from the
Torq-Tronics
®
unit. Do not move the cover and battery pack any further from the unit than is nec-
essary to install the batteries! The wires from the battery pack to the internal elec-
tronics are small and soldered at each end. Placing excessive tension on them will
break the wires and necessitate returning the unit for repair!
c. Open the package containing the supplied batteries.
d. Following the battery orientation shown inside the battery pack, install all four bat-
teries into it. It is important that proper battery orientation be maintained!
e. Gently push the wires connecting the battery pack to the internal electronics while
replacing the battery cover back in its' original position.
f. Reinstall the two Phillips head screws used to retain the battery cover in place. The
screws should only be tightened snug.
2. The second step in providing power to your Torq-Tronics is connection to the AC power
source.
a. Unwrap the trickle charger supplied with your
Torq-Tronics
®.
b. Plug the charger pin into the charger pin receptacle on the right side of the unit.
c. Plug the other end of the charger into a properly wired 120 VAC (240 VAC in
Europe) outlet.