Sturtevant Richmont 10191, Руководство пользователя

Страница: 42 / 51

13) Again hang the weight platform (hook) and the full-scale weights (100%) (found in the
"
Calibration Table - Torq-Tronics ® Models
") on the calibration arm - gently, and
imparting as little motion to the weights as possible. Wait for the arm to completely
stop moving, then enter
:CM0 into the terminal software and press the Enter key.
Observe acknowledgement of the 100% clockwise calibration point.
14) Remove weights and reverse calibration arm to the counter-clockwise direction, and
press the Zero key.
15) Hang weight platform and full-scale (100% load as found in the "
Calibration Table -
Torq-Tronics ® Models
") load on the arm, gently. Wait until the arm has completely
stopped moving, then remove the weights and platform.
16) Wait one minute, then press the ZERO button on the tester.
17) Repeat steps 14, 15, and 16 two more times, then proceed to step 18.
18) Hang weight platform and 10% weights on the calibration arm, gently. Wait until the
arm has completely stopped moving.
19) Type :CM3 into the terminal program and press the Enter key. Observe acknowledge-
ment of calibration 10% counter-clockwise.
20) Hang weight platform and 10% weights on the calibration arm, gently. Wait until the
arm has completely stopped moving.
21) Type :CM4 into the terminal program and press the Enter key. Observe acknowledge-
ment of calibration 100% counter-clockwise.
22) To save calibration, type :CM5 into the terminal program and press the Enter key.
Observe acknowledgement of calibration save.
Calibration Verification Procedure
1) Disconnect the RS-232 serial cable from the tester.
2) Reverse calibration arm from counter-clockwise direction to clockwise direction, and
press the Zero key.
3) Hang weight platform and full-scale (100% load as found in the "
Calibration Table -
Torq-Tronics ® Models
") load on the arm, gently. Wait until the arm has completely
stopped moving, then remove the weights and platform.
4) Wait one minute, then press the ZERO button on the tester.