SIME Brakes
13/05/16
M10054-02-A
Installation and maintenance
SIDEOS Box 2
5/17
Non contractual photographs.
Instructions of this manual must be adhered to, to obtain the performance and the safety of operation of the equipment.
Encoder and limit switch 51 questionnaire
No. Q01390-01
Dimensions limit switch 51
No. T10003-01
Installation and maintenance SIDEOS One
No. M10054-01
Limit switch 51 - Stromag
Catalog
No. D142
Installation and maintenance No. 151-00004
EMC
No. 900-00001
>
Overspeed loop feedback terminals 35-36 and 37-38
-C4 and C5 contacts are used to drive directly 2 contactors
inserted on the feed line of the safety brakes.
-The NC contact of each contactor is inserted into the res-
pective overspeed feedback loop. This contact must impe-
ratively close when the C4 et C5 contacts open to indicate
an Overspeed, this allowing the
SIDEOS Box 2
to check
the opening of the associated contactors.
-In case of a direct use of C4 and C5 contacts in an input
loop of a safety relay, these loop feedbacks can be shun-
ted. (see diagram ch. 4-2).
ATTENTION
!
In this case, taking into account of KFS1 and
KFS2 contactors triggering and possible short-
circuits in the connection cables of C4 and
C5 contacts are no more controlled by the
SIDEOS box 2
unit.
The customer will make sure that all these faults
will be detected by its system (for example : sa-
fety relay with input loops control).
The achieved performance level will then de-
pend on the performance level achieved by the
safety relay
>
Dynamic Slipping selection on SIDEOS One N°1
terminals 39-40
-Terminals 39-40 are dircetly linked to the terminal box to
select the Dynamic Slipping on the SIDEOS One N°1.
-TS parameter on the SIDEOS N°1 will be put on CW or
CCW according to the rotation direction of the encoder 1
during a Descent order.
-CW = clockwise, watching the encoder axis in front view.
-CCW = counter-clockwise, watching the encoder axis in
front view.
>
Dynamic Slipping selection on SIDEOS One N°1
terminals 41-42
-Terminals 41-42 are dircetly linked to the terminal box to
select the Dynamic Slipping on the SIDEOS One N°2
-TS parameter on the SIDEOS N°2 will be put on CW or
CCW according to the rotation direction of the encoder 2
during a Descent order.
-CW = clockwise, watching the encoder axis in front view.
-CCW = counter-clockwise, watching the encoder axis in
front view.
SIME Brakes
www.stromag.com -
Customer service / Tel. : +33(0)1 49 90 32 20 / Fax : +33(0)1 49 89 06 38
