Stratasys 180-00108 uPrint, Руководство пользователя, Страница: 28 / 68

Stratasys Document Number 206465-0001
Setup 28
A. Close the Add 3D Printer pop-up window and click the Add Manually button in the 3D Printers
pop-up window.
B. in the pop-up window Add 3D Printer , enter a Name and Location (your choice) for your printer in
the appropriate fields.
C. Enter the Dynamic IP Address for your printer (from Step 2B) in the appropriate field.
D. Select the appropriate printer type from the drop down list.
E. Click Add Printer and close the 3D Printer pop-up window.
F. If you get an “Error: Unable to connect to printer” message it may be that your PC is not
configured for Dynamic Networking. To configure your PC for Dynamic Networking:
i. From the Control Panel of your PC, double click on Network and Internet Connections .
ii. Double click on Network Connections , then double click on Local Area Connection .
iii. Scroll the Local Area Network Connection Properties window to find the Internet Protocol
(TCP/IP) selection. Click on Internet Protocol (TCP/IP) and then click on the Properties
button.
iv. From the General tab of the Internet Protocol (TCP/IP) properties pop-up window, click on
the Obtain IP Address Automatically radio button.
v. Click OK and then OK again.
vi. After allowing your PC a minute or so to adjust to the new setting, your PC should connect to
your printer.
vii. If you are still unable to connect to your printer, recheck your connections and settings.