Storz 11302 BDX, Инструкция по эксплуатации

Страница: 26 / 64

Inspecting the Image Quality
Check the image quality before using the Flexible Intubation Video Endoscope. Do not use the scope if the image is
missing, or unclear/blurry.
Warning: If the image fails or there is interference during use in the patient, put the distal tip into the neutral position
and remove the Flexible Intubation Video Endoscope from the patient’s body gently and carefully. If the Flexible
Intubation Video Endoscope is used in the patient after the image has failed or when there is interference, this may
result in serious injury to the patient.
Switching Off the Monitor
Standby
: Briefly pressing the power button
l
will set the monitor to standby operation mode. In the case of brief
interruptions, this enables the monitor to be ready for operation again quickly. The standby mode is indicated by a
flashing green pilot lamp
k
above the power button.
After 5 minutes, the system switches itself from standby mode to the off mode.
Power off: Pressing the power button
l
for more than approximately 3 seconds will switch off the monitor. The green
pilot lamp k will go out.
Note: When the monitor is switched off, the integrated light source in the Flexible Intubation Video Endoscope also
switches off.
Note : A more detailed description of the functions can be found in the instruction manual for the monitor “C-MAC
®
Monitor 8403 ZX” (P/N 96076008D).
Installation and Operating
Instructions
26
l