StorageTek L180, Руководство по обслуживанию

Страница: 61 / 266

95897 Fifth Edition 2-17
Configuration Overview
Drive Entries (LTO Fibre Channel Only)
You may either set a hard Fibre Channel address of 0 for LTO drives or allow
the address to be set automatically, through arbitration.
Note: Before you enter an LTO Fibre Channel address to 0, you must first set
the drive’s Fibre Channel hard address option to
enabled
.
If you configure the drive for soft addressing, you allow the network to
configure the address. To do this, you must set the Fibre Channel hard
address option to
disabled
. The default for this option is
disabled
.
To set this value:
1. Press the arrow buttons to scroll to the drive you wish to configure and
press the
SELECT
button. The screen will allow you to select hard
addressing to
enabled
or
disabled
.
2. Press the up and down arrow buttons to line up with your choice. Press
SELECT
and:
• If you select
enabled
, the hard address will be set to 0
• If you select
disabled
, the address will arbitrate through the channel.
3. Press the
SELECT
button to save the changes. Press the
MENU
button to
abort.
4. If you wish to set other configuration values, continue with the next section.
- If you have already changed the library’s SCSI ID or Port 0 address and
are planning to exit the Main Configuration Menu at this time, you must
press the
RESET
button.
- If you wish to set other configuration values, continue with the next
section.
- If you have not changed the library’s SCSI ID or Port 0 address and are
not setting other configuration values, press the
MENU
button until you
exit all menus.
Drive Entries ~ 9840/T9840B
To configure a 9840/T9840B drive:
1. The drive must have firmware version 1.24 or higher. Check the drive’s
firmware version, by selecting
DRIVE INFO
from the Main Menu.
2. Configuring a 9840/T9840B/T9940 drive might involve more than setting the
drive’s SCSI ID and bus status.
Refer to the
9840/T9840B/T9940 Tape Drive Service Reference Manual
for
information about 9840/T9840B/T9940 drive configuration options and
instructions.