Status SOLID 300, Руководство пользователя

Страница: 40 / 56

40
1.1. OPERATING CONDITIONS
Maximum ambient temperature in
normal use is +40 °C; the average of
temperatures over a 24-hour period
should not 35 °C. Minimum
ambient temperature allowed is -5 °C.
Surrounding air should be clean;
relative humidity should not exceed
50 % at the maximum temperature
of +40 °C. Higher relative humidity is
allowed at lower ambient temperature
(e.g. 90 % at +20 °C).
If the machine is not operational for 5
minutes, it turns off. You need to press
On/Off button to turn it back on.
1.2. IMPORTANT SAFETY INSTRUCTIONS
a.) Working surface must be dry,
normal temperature (not hot) and
clear from obstructions.
b.) Before connecting the appliance
to mains socket, check the power
cord, plugs and socket. If you
observe any defect, contact our
repair service listed below.
c.) Machine should be cleaned only
with a dry or slightly damp cloth.
d.) Never touch the Sealing Strip when
using the machine (Item 15 in
Figure 1) – it may be hot.
e.) Use the machine only for the purpo -
ses described in the User Manual.
f.) If the supply cord is damaged, it
must be replaced by the manu-
facturer, its service agent or simi-
larly qualified persons in order to
avoid a hazard.
g.) This machine can be used by chil -
dren aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of the
machine in a safe way and under -
stand the hazards involved.
h.) Children shall not play with the
machine. Cleaning and user
maintenance shall not be made by
children without supervision.
i.) Warranty is invalid if:
• The machine has been tampered
with.
• The machine has been used for
unintended purposes.
• Safety regulations and instructi -
ons in the User Manual were not
respected and followed.
The manufacturer will not accept
responsibility for any damage that may
occur as a result of not following the
User Manual or improper use.
1. SAFETY INSTRUCTIONS AND INTRODUCTION