Standard Horizon HX890, Руководство пользователя

Страница: 99 / 116

97
1. The RESET screen is displayed on step 1 in “ Checking
the Request code ”.
2. Press the [CH▼]/[CH▲] key to select “ PASSWORD ", then
press the [ SELECT ] soft key.
The password input screen will appear.
REQUEST CODE
BACK
CONFIGURATION
PASSWORD
SELECT
USER MMSI RESET
3. Input the acquired reset code.
• Select the character with the [CH▼]/[CH▲]/[◄]/[►] keys
•
Press the [
SELECT
] soft key to input the character
• Press the [ SELECT ] soft key to select “ ← ” or “ → ” on the
screen to move the cursor.
• Press the [ SELECT ] soft key to select “ Delete ” on the
screen to delete the selected character
BACK SELECT FINISH
CONFIGURATION
PASSWORD INPUT
a&
[
Z Y
1 2 3 4 5 6 7 8 9 0
N O P Q R S T U V W X
M B A C D E F G H I J K L
Delete
- ---- -----
-
4. Press the [ FINISH ] soft key.
If the reset is successful, “ COMPLETE! ” will appear on
the screen.
If the error message is displayed, input the reset code again.
OK
CONFIGURATION
USER MMSI RESET
USER MMSI
COMPLETE!
5. Press the [ OK ] soft key to return to setup screen.
NOTE
The acquired reset code is available only one time.
18.4 TROUBLESHOOTING CHART
SYMPTOM PROBABLE CAUSE REMEDY
The USA/INTL/CAN modes
do not function.
Proper operation not
followed.
Specify the item number from
“SETUP MENU” – “CH SETUP” –
“CH GROUP”.
Cannot output sound by
pressing and holding the
[SQL ] key.
Low battery. Charge battery. Refer to section 6
of this manual.
Audio volume level is too
low.
Press the [ VOL+ ] key until back-
ground noise outputs.
Cannot transmit a DSC Call. MMSI number is not
programmed.
Program the MMSI number. Refer
to section “ 6.4.2 Programming
the MMSI ”.
Cannot fix the GPS satellites. Internal GPS receiver is
“off”.
Internal GPS receiver is “on”. Refer
to “ 16.1 GPS ON/OFF ”.
Poor location for GPS
satellite reception.
Move to a less obstructed position.
Charge indicator does not
appear on the display
when charging a battery.
Defective battery SBR-13LI . Contact Standard Horizon dealer.
The transceiver is not set
onto the SBH-32 Charger
Cradle properly.
Set the transceiver onto the SBH-32
Charger Cradle properly.
Power is not supplied to the
SBH-32
Charger Cradle.
Connect SAD-25 or E-DC-19A to
the
SBH-32
Charger Cradle for AC/
DC power supplies.